Filter
Top Products
5 - 34
5. PARAMETERS
No. Symbol Name and function
Initial
value
Unit
Setting
range
PD11 *DO3 Output signal device selection 3 (CN6-16)
Any output signal can be assigned to the CN6-16 pin.
The devices that can be assigned and the setting method are the same as in
parameter No. PD09.
0
Select the output device of the CN6-16 pin
0
0024h Refer to
name and
function
column.
PD12 For manufacturer setting
Do not change this value by any means.
0C00h
PD13 0000h
PD14 0800h
PD15 0000h
PD16 *DIAB
Input polarity selection
Used to set the proximity dog input polarity. (Refer to section 4.7.)
0
Proximity dog input polarity
0: OFF indicates detection of the dog.
1: ON indicates detection of the dog.
00
0000h Refer to
name and
function
column.
PD17 For manufacturer setting
Do not change this value by any means.
0000h
PD18 0000h
PD19 *DIF Response level setting
Used to select the input.
000
Input filter
If external input signal causes chattering due
to noise, etc., input filter is used to suppress it.
0: None
1: 0.88[ms]
2: 1.77[ms]
3: 2.66[ms]
4: 3.55[ms]
5: 4.44[ms]
0002h Refer to
name and
function
column.