Filter
Top Products
5 - 4
5. PARAMETERS
5.1.4 Selection of regenerative option
Parameter
Initial
value
Unit Setting range
No. Symbol Name
PA02 *REG Regenerative option 0000h Refer to the text.
POINT
This parameter is made valid when power is switched off, then on after
setting.
Wrong setting may cause the regenerative option to burn.
If the regenerative option selected is not for use with the servo amplifier,
parameter error (A37) occurs.
Set this parameter when using the regenerative option, brake unit, power regeneration converter, or power
regeneration common converter.
Selection of regenerative option
00: Regenerative option is not used
For MR-J3-10T, regenerative resistor is not used.
For MR-J3-20T 40T 60T(4) to 700T(4) built-in regenerative
resistor is used.
Supplied regenerative resistors or regenerative option is used with
the MR-J3-11KT(4) to 22KT(4) servo amplifier.
01: FR-BU2-(H) FR-RC-(H) FR-CV-(H)
02: MR-RB032
03: MR-RB12
04: MR-RB32
05: MR-RB30
06: MR-RB50(Cooling fan is required)
08: MR-RB31
09: MR-RB51(Cooling fan is required)
80: MR-RB1H-4
81: MR-RB3M-4(Cooling fan is required)
82: MR-RB3G-4(Cooling fan is required)
83: MR-RB5G-4(Cooling fan is required)
84: MR-RB34-4(Cooling fan is required)
85: MR-RB54-4(Cooling fan is required)
FA:When regenerative resistors or regenerative option supplied to MR-
J3-11KT(4) to 22KT(4) are cooled by cooling fans to increase
00
Parameter No. PA02