13 - 97
13. OPTIONS AN
D AUXILIARY EQUIPMENT
13.22 Junction terminal block MR-TB50
(1) How to use the junction terminal block
Always use the junction terminal block (MR-TB50) with the junction terminal block cable (MR-J2M-CN1TBL
M) as a set. A connection example is shown below.
MR-J3-D01
CN10
Junction terminal block
MR-TB50
Cable clamp
MR-J2M-CN1TBL M
Ground the junction terminal block cable on the junction terminal block side with the standard accessory
cable clamp fitting (AERSBAN-ESET). For the use of the cable clamp fitting, refer to section 13.15 (2)(c).
(2) Outline drawing
235
50
25
Approx.
25
9
2
1
50
49
[Unit: mm]
MITSUBISHI
MR-TB50
2- 4.5
244
2.5
46.5
1 3 5 7 9 111315171921232527293133
2 4 6 8 101214161820222426283032
3537394143454749
3436384042
44
464850
2
Terminal screw: M3.5
Applicable cable: 2mm
Crimping terminal width: 7.2mm or less.