Filter
Top Products
Installation
1705A Spectrum Monitor
3-5
LNBPOWER
70MHz
SPECTRUM MONITOR
333--3990 --01
INPUT
BESCHLEUNIGUNGSSPANNUNGKLEINERALS
20kV
DIEINDIESEMGERATENTSTEHENDE
RONTGENSTRAHLUNG ISTAUSREICHENDABGESCHIRMT
WARNING
TOAVOIDELECTRICALSHOCK,THEPOWER
CORDPROTECTIVEGROUNDING CONDUCTOR
MUST BECONNECTEDTOEARTHGROUND.
0.7AMAX
50/60Hz
90-250
V
REPLACEFUSEONLYWITH
250V2AFTYPE
LBAND
INPUT
!
ON
!
LNBPOWER
OFF
+18VDC@250mA
ON
Cabinet Securing Screws
Figure 3-4: Cabinet securing screws
The optional WFM7F05 side-by-side rack adapter, shown in Figure 3-5, consists
of two attached cabinets. It can be used to mount the 1705A and another
half-rack width instrument in a standard 19-inch rack.
CAUTION. Be sure to read and follow the instructions that are shipped with the
rack adapter.
Use the correct sleeve for your product. The ventilation holes and EMI shielding
on the sleeves are specially designed to meet the requirements of the instruments
for which they were intended. If you use the wr ong sleeve, it could damage the
instrument and cause overheating problems.
When working with instruments that are not enclosed in a chassis, you must
observe static precautions. You must also be careful not to damage circuit board
mounted components or interconnection wiring when sliding a sleeve over these
products.
Rack Adapter