Filter
Top Products
Setting a stage that fits your image
1 Touch [Staging] in Sound menu.
2 Touch the desired stage setting.
p The [Living Room] setting that emphasizes
midrange sound hardly has any effect near
the maximum volume level.
p When you set staging other than [Off], the
high pass filter (HPF) setting turns [Off].
= For details, refer to Using the high pass filter
on the next page.
Adjusting a position effect
You can select a listener position that you
want to make as the center of sound effects.
1 Touch [Staging] in Sound menu.
2 Touch [Position].
3 Touch the desired position.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Touch [Loudness] in Sound menu.
2 Touch [On] to turn loudness on.
To turn loudness off, touch [Off].
3 Touch c or d to select a desired level.
Each time you touch c or d selects level in
the following order:
Low — Mid — High
Using subwoofer output
This navigation system is equipped with a sub-
woofer output which can be turned on or off.
p When the subwoofer output is on, you can
adjust the cut-off frequency, the output
level and the phase of the subwoofer.
1 Touch [Sub Woofer] in Sound menu.
When [Preout] (the subwoofer controller set-
ting in Initial menu) is [Sub. W], you can se-
lect [Sub Woofer].
= Refer to Setting the rear output and subwoo-
fer controller on page 137.
2 Touch [On] to turn subwoofer output
on.
To turn subwoofer output off, touch [Off].
3 Touch [Reverse] or [Normal] to select
the phase of subwoofer output.
4 Touch [+] or [-] to adjust the output
level of the subwoofer.
+6 to -6 is displayed as the level is increased
or decreased.
5 Touch c or d to select cut-off fre-
quency.
Each time you touch c or d selects cut-off fre-
quencies in the following order:
50 — 80 — 125 (Hz)
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through navigation
system’s low pass filter (for the subwoofer),
but is output through the RCA output.
1 Touch [Non Fading] in Sound menu.
Only when [Preout] (the subwoofer controller
setting in Initial menu) is [Full], you can select
[Non Fading].
= Refer to Setting the rear output and subwoo-
fer controller on page 137.
2 Touch [On] to turn non fading output
on.
To turn non fading output off, touch [Off].
3 Touch [+] or [-] to adjust the output
level of the non fading.
+6 to -6 is displayed as the level is increased
or decreased.
Customizing the AV Source Setting
En
133
Chapter
09
Customizing the AV Source Setting