Filter
Top Products
You cannot position your vehicle
on the map or the positioning
error is large.
Something covers the GPS antenna. Do not cover the GPS antenna with spray
paint or vehicle wax, because this may block
the reception of GPS signals. Snow buildup
can also degrade the signals.
Signals from the vehicle’s speed
pulse are not being picked up prop-
erly.
Check that the cables are properlyconnected.
If necessary, consult the dealer that installed
the system.
The navigation system may not be
mounted securely in your vehicle.
Check that the navigation system is securely
mounted and, if necessary, consult the dealer
that installed the system.
Your vehicleis operating in Simple
hybrid mode.
Connect the speed signal input (pink lead
wire) of the power cable correctly, and reset
the 3D Hybrid Sensor memory ([Learning
Status]).
The navigation system is installed
with an extreme angle exceeding
the limitation of the installation
angle.
Confirm the installation angle. (The naviga-
tion system must be installed within the al-
lowed installation angle. For details, refer to
“Installation Manual”.)
Indication of the position of your ve-
hicle is misaligned after a U-turn or
reversing.
Check whether or not the reverse gear signal
input lead (violet) is connected properly. (The
navigation system works properly without the
lead connected, but positioning accuracy will
be adversely affected.)
The map continually reorients it-
self.
The traveling direction is set to
Heading up.
Touch
on the screen and change the map
display.
Tracking marks are not dis-
played.
[Tracking Display] is turned off. Check [Tracking Display] settings and make
sure [Always]or[This Trip] is selected.
(Page 83)
The daylight display is used
even when the vehicle lights are
on.
[Daytime] is set to [Day/Night Dis-
play].
Check [Day/Night Display] setting and make
sure [Nighttime] is selected. (Page 83)
The orange/white lead is not con-
nected.
Check the connection.
The system will not switch on or
will not operate.
Installation or connection has been
carried out incorrectly.
Check with your dealer.
The display is very dim. The vehicle’s light is turned ON, and
[Nighttime] is selected on [Day/
Night Display].
Read about [Day/Night Display] setting and,
if desired, select [Daytime]. (Page 83)
The vehicle cabin temperature is ex-
tremely low.
A Liquid Crystal Display (LCD) is used, and
such displays tend to darken when cold. Wait
for the vehicle to warm up.
Picture quality adjustment of the
display is not correct.
Refer to “Page 142” to adjust the picture qual-
ity.
No sounds are heard.
The volume level will not rise.
The volume level is low. Adjust the volume level.
The attenuator or mute is on. Turn the attenuator or mute off.
The speaker lead is disconnected. Check the connection.
Adjusting the volume of naviga-
tion guidance and beeps is not
possible.
You cannot adjust them with VO-
LUME knob.
Turn the volume upor down according to [Vo-
lume]in[Settings] menu. (Page 80)
Appendix
En
145
Appendix
Appendix