Filter
Top Products
Interrupt and Mode Control
DSP56366 24-Bit Digital Signal Processor User Manual, Rev. 4
2-8 Freescale Semiconductor
Table 2-8 Interrupt and Mode Control
Signal Name Type
State during
Reset
Signal Description
MODA/IRQA
Input Input Mode Select A/External Interrupt Request A — MODA/IRQA is an active-low
Schmitt-trigger input, internally synchronized to the DSP clock. MODA/IRQA
selects the initial chip operating mode during hardware reset and becomes a
level-sensitive or negative-edge-triggered, maskable interrupt request input
during normal instruction processing. MODA, MODB, MODC, and MODD select
one of 16 initial chip operating modes, latched into the OMR when the RESET
signal is deasserted. If the processor is in the stop standby state and the
MODA/IRQA
pin is pulled to GND, the processor will exit the stop state.
This input is 5 V tolerant.
MODB/IRQB
Input Input Mode Select B/External Interrupt Request B — MODB/IRQB is an active-low
Schmitt-trigger input, internally synchronized to the DSP clock. MODB/IRQB
selects the initial chip operating mode during hardware reset and becomes a
level-sensitive or negative-edge-triggered, maskable interrupt request input
during normal instruction processing. MODA, MODB, MODC, and MODD select
one of 16 initial chip operating modes, latched into OMR when the RESET
signal is deasserted.
This input is 5 V tolerant.
MODC/IRQC
Input Input Mode Select C/External Interrupt Request C — MODC/IRQC is an active-low
Schmitt-trigger input, internally synchronized to the DSP clock. MODC/IRQC
selects the initial chip operating mode during hardware reset and becomes a
level-sensitive or negative-edge-triggered, maskable interrupt request input
during normal instruction processing. MODA, MODB, MODC, and MODD select
one of 16 initial chip operating modes, latched into OMR when the RESET
signal is deasserted.
This input is 5 V tolerant.
MODD/IRQD
Input Input Mode Select D/External Interrupt Request D — MODD/IRQD is an active-low
Schmitt-trigger input, internally synchronized to the DSP clock. MODD/IRQD
selects the initial chip operating mode during hardware reset and becomes a
level-sensitive or negative-edge-triggered, maskable interrupt request input
during normal instruction processing. MODA, MODB, MODC, and MODD select
one of 16 initial chip operating modes, latched into OMR when the RESET
signal is deasserted.
This input is 5 V tolerant.
RESET
Input Input Reset — RESET is an active-low, Schmitt-trigger input. When asserted, the
chip is placed in the Reset state and the internal phase generator is reset. The
Schmitt-trigger input allows a slowly rising input (such as a capacitor charging)
to reset the chip reliably. When the RESET
signal is deasserted, the initial chip
operating mode is latched from the MODA, MODB, MODC, and MODD inputs.
The RESET
signal must be asserted during power up. A stable EXTAL signal
must be supplied while RESET is being asserted.
This input is 5 V tolerant.