Filter
Top Products
11. OPTIONS AND PERIPHERAL EQUIPMENT
11 - 13
To remove the built-in regenerative resistor mounted on the back of MR-JE-40B to MR-JE-100B, refer to
the following illustration and follow the procedures 1) to 3).
1) Disconnect the wirings of the built-in regenerative resistor from the power connector (CNP1).
(Refer to section 3.3.3 (2) (b).)
2) Remove the wirings of the built-in regenerative resistor from the closest position to the power
connector (CNP1) in order. Please pay full attention not to break the wirings.
3) Remove the screw fixing the built-in regenerative resistor and dismount the built-in regenerative
resistor.
(Note)
3)
1)
2)
Note. Screw size: M3
Tightening torque: 0.72 [N•m]