Filter
Top Products
3. SIGNALS AND WIRING
3 - 9
(4) For 1-phase 200 V AC to 240 V AC power supply of MR-JE-200B
POINT
For MR-JE-_B servo amplifiers, the hot line forced stop function is enabled at
factory setting. For MR-J4-_B servo amplifiers, the hot line forced stop function
is disabled at factory setting.
If an alarm occurs, the hot line forced stop function outputs hot line forced stop
signals to all servo amplifiers before a communication to the controller is cut.
Then, servo amplifiers will be in the [AL. E7.1 Controller forced stop warning]
state and will decelerate to a stop.
The hot line forced stop function can be disabled with [Pr. PA27].
Configure the power supply circuit which turns off magnetic contactors of all
servo amplifiers after detection of alarm occurrence on the controller side at
alarm occurrence.
Connect the 1-phase 200 V AC to 240 V AC power supply to L1 and L2. One of
the connecting destinations is different from MR-JE-100B or less Servo
Amplifier's.
MBR
DOCOM
CN3
RA1
U
V
W
M
CN2
CN3
EM2
DICOM
MCCB
L1
L2
L3
P+
N-
D
C
U
V
W
CNP1
CNP2
MC
MC
SK
MC (Note 8)
(Note 3)
24 V DC (Note 9)
24 V DC (Note 9)
Electromagnetic
brake interlock
Servo amplifier
(Note 1)
Servo motor
Motor
Encoder
(Note 2)
Encoder cable
(Note 4, 7)
Forced stop 2
(Note 3)
(Note 6)
Power
supply
(Note 7)
(Note 5)
Alarm
OFF
ON
EMG stop switch
1-phase
200 V AC to
240 V AC