Filter
Top Products
5. PARAMETERS
5 - 1
5. PARAMETERS
CAUTION
Never adjust or change the parameter values drastically as doing so will make the
operation unstable.
If fixed values are written in the digits of a parameter, do not change these values.
Do not change parameters for manufacturer setting.
Do not set a value other than the described values in each parameter.
POINT
When you connect the amplifier to a servo system controller, servo parameter
values of the servo system controller will be written to each parameter.
Some parameters and their ranges may not be configured depending on the
servo system controller model, servo amplifier software version, and MR
Configurator2 software version. For details, refer to the servo system controller
user's manual. Check the software version of the servo amplifier using MR
Configurator2.
5.1 Parameter list
POINT
The parameter whose symbol is preceded by * is enabled with the following
conditions:
*: To enable the parameter value, power off the servo amplifier for 1 s or longer
and power on the amplifier or reset the controller after setting the parameter.
However, the time will be longer depending on a setting value of [Pr. PF25
Instantaneous power failure tough drive - Detection time] when "instantaneous
power failure tough drive selection" is enabled in [Pr. PA20].
**: To enable the parameter value, power off the servo amplifier for 1 s or longer
and power on the amplifier. However, the time will be longer depending on a
setting value of [Pr. PF25 Instantaneous power failure tough drive -
Detection time] when "instantaneous power failure tough drive selection" is
enabled in [Pr. PA20].