Filter
Top Products
7 - 13
7. DISPLAY AND OPERATION
7.5.3 Operation method
(1) Setting of 5 or less-digit value
The following example provides the after-power-on operation procedure to set "1" in the auxiliary
function of point table No.1.
Press MODE three times.
Press SET once.
Press SET twice.
Press UP five times.
Press UP or DOWN to choose point table No. 1.
··········The setting can be changed during flickering.
Use UP or DOWN to change the setting.
Press SET to enter the value.
Press UP once.
··········The setting of the specified point table No. flickers.
··········The point table No. appears.
Note. The example assumes that the status display screen that appears at power-on has been
set to the servo motor speed in parameter No. 18.
(Note)
Press "UP" or "DOWN" after completion of the setting to return to the setting item screen. Further,
press "UP" and "DOWN" together to return to the point table No. display screen.