Filter
Top Products
7 - 15
7. DISPLAY AND OPERATION
7.6 Parameter mode
POINT
To use the expansion parameters, change the parameter No. 19 (parameter
write inhibit) value. (Refer to section 5.1.1)
7.6.1 Parameter mode transition
After choosing the corresponding parameter mode with the "MODE" button, pressing the "UP" or "DOWN"
button changes the display as shown below.
Special parameters
Expansion parameters 2
Expansion parameters 1
Basic parameters
Parameter No. 0 Parameter No. 20
Parameter No. 54
Parameter No. 78
Parameter No. 79Parameter No. 55Parameter No. 21Parameter No. 1
Parameter No. 18
Parameter No. 19
Parameter No. 52
Parameter No. 53
Parameter No. 76
Parameter No. 77
Parameter No. 89
Parameter No. 90
To status display mode
UP
DOWN
MODE
The parameter whose abbreviation is marked
*
is made valid by switching power off, then on after
changing its setting. (Refer to section 5.1.2)