Filter
Top Products
14 - 13
14. OPTIONS AND AUXILIARY EQUIPMENT
b) Control circuit terminal
POINT
Undertightening can cause a cable disconnection or malfunction.
Overtightening can cause a short circuit or malfunction due to damage to
the screw or the brake unit.
A
RES
PC
B
SD
BUE
C
MSG
SD
MSG
SD SD
Jumper
Terminal block
6mm
Sheath
Core
Wire the stripped cable after twisting to prevent the
cable
from becoming loose. In addition, do not solder it.
Screw size: M3
Tightening torque: 0.5N
m to 0.6N m
Cable size: 0.3mm
2
to 0.75 mm
2
Screw driver: Small flat-blade screwdriver
(Tip thickness: 0.4mm/Tip width 2.5mm)
(c) Crimping terminals for P and N terminals of servo amplifier
POINT
Always use recommended crimping terminals or equivalent since some
crimping terminals cannot be installed depending on the size.
Servo amplifier Brake unit
Number of
connected
units
Crimping terminal Applicable tool Manufacturer
MR-J2S-350CP FR-BU2-15K 1
FR-BU2-15K 1
MR-J2S-500CP
FR-BU2-30K 1
FVD5.5-S4 YNT-1210S
Japan Solderless
Terminal
MR-J2S-700CP FR-BU2-30K 1