Filter
Top Products
7 - 6
7. MR Configurator
(4) Parameter value batch-write ( d) )
Click the "Write All" button to write all parameter values to the servo amplifier.
(5) Parameter default value indication ( e) )
Click the "Set to default" button to show the initial value of each parameter.
(6) Basic settings for parameters ( g) )
Used to make the basic settings such as control mode selection and absolute position detection system
selection.
(7) Basic setting parameters ( h) )
Used to make the basic settings for the servo amplifier. Select a parameter to be changed the setting, enter
a new value to "Set value" and click "Enter".
(8) Gain/Filter parameters ( i) )
Used to adjust the gain manually. Select a parameter to be changed, enter a new value to "Set value" and
click "Enter".
(9) Extension setting parameters ( j) )
Used to make the setting unique to MR-J3-
T servo amplifier. Select a parameter to be changed, enter a
new value to "Set value" and click "Enter".
(10) I/O setting parameters ( k) )
Used to change the I/O device of the servo amplifier. Select a parameter to be changed, enter a new
value to "Set value" and click "Enter".
(11) Parameter block ( l) )
Used to set the availability of parameter write.
(12) Parameter data file read
Used to read and display the parameter values stored in the file. Use the "Project" menu on the menu
bar to read.
(13) Parameter value storage
Used to store all parameter values being displayed on the window into the specified file. Use the
"Project" menu on the menu bar to store.
(14) Parameter data list print
Used to print all parameter values being displayed on the window. Use the "Project" menu on the menu
bar to print.
(15) Parameter list window closing ( f) )
Click the "Close" button to close the window. If the "Close" button is clicked without (1) parameter value
write or (4) parameter value batch-write being performed, the parameter value changed is made invalid.