Filter
Top Products
8 - 13
8. PARAMETER UNIT (MR-PRU03)
8.5.5 Parameter mode
The flowchart below shows the procedure for setting parameters.
DATA
PARAM
Select a parameter group.
First parameter number
is displayed.
e.g. To select the
gain/filter parameter,
press:
Write
Write is completed.
The following message
appears if switching
power off or on is needed
to enable the setting.
e.g. To select
parameter No.PB10,
press:
1 0
e.g. To set setting
value
"
1234
"
,
press:
1 2 3 4
The parameter number,
abbreviation and setting value
are displayed.
Press the "Fn" key to display
the range.