Filter
Top Products
8 - 14
8. PARAMETER UNIT (MR-PRU03)
8.5.6 Point table mode
The flowchart below shows the procedure for setting point table data.
DATA
PARAM
e.g. To set setting
value "4567.89",
press:
SHIFT
Servo motor speed display
Acceleration time
constant display
Deceleration time
constant display
Dwell display
Auxiliary function display
Select a point table No.
Position data display
e.g. To set point
table No."255"
press:
Table read screen
4 5 6 7
8 9
1STEP
2 5 5
Select an item with
the keys
or numeric keys.
Enter
e.g. To set setting
value "0", press:
0
Enter
(Note)
Press the "Fn" key
to display the range.
Point table data is
displayed.
POS
SPD
ACC
DEC
DWELL
AUX
: Point data
: Servo motor
speed
: Acceleration
time constant
: Deceleration
time constant
: Dwell
: Auxiliary
function
""
Note. This applies to all types of data.