Filter
Top Products
100 DL-V3 User Manual Rev 3
B.14 GROUPCOM Associate Port Configurations with a Group
This command allows you to associate one or more port configurations with a group. It is identical to
the standard OEMV COM command but with these exceptions:
• an additional leading argument is used to specify the associated groupname
• configuration of COM3 and USB ports is not supported for GROUPCOM
1. GROUPCOM is not supported on the DL-V3’s COM3 port because it may cause the COM3
Bluetooth or Ethernet applications to become non-responsive. Both applications are
preconfigured to the fixed baud rate of 1152000.
2. If you add GROUPCOM settings to a particular group, they do not take effect until the next
time a GROUPUSE command is run for that group.
If added, each distinct group may have unique settings for GROUPCOM.
3. Use of the GROUPCOM command does not affect the INTERFACEMODE or COMVOUT
settings for a group.
The set command provides the port settings that are configured the next time the named group is
executed.
The clear command removes any port settings for the specified group name and port. No port
configuration is performed for the specified port the next time the group is executed.
The default command removes any port settings for the specified group name and port. No port
configuration is performed for the specified port the next time the group is executed.
Syntax
groupcom clear | default groupname [com1|com2|aux]
B.14.1 Groupuse Translation
groupuse start
• Settings for each configured groupcom port are set
groupuse stop
• N/A