Filter
Top Products
Installation and Setup Chapter 2
DL-V3 User Manual Rev 3 27
Figure 5: Ethernet Port
Figure 6: Bluetooth Interface at the Top of the DL-V3
5. Line up the red mark on the power cable connector with the red mark of the INPUT 9-28 V
connector, see Figure 7 below, on the back of the DL-V3, and insert the power cable. See also
Section 2.1.9, Applying Power to the Receiver on Page 32.
Figure 7: Power Port
6. Plug in the adapter and/or connect, turn on the power supply and press the button on the front
face of the DL-V3. The power LED on the front of the receiver glows green when the DL-V3
is turned on and is properly powered.