Filter
Top Products
94 DL-V3 User Manual Rev 3
B.9 FRESET Clear Selected Data from NVM and Reset
The OEMV freset command is extended to include DL-V3 features. An additional target field,
userdata (value = 10), resets only the DL-V3 user data NVM, thereby resetting all parameters
indicated in this document as “Stored in NVM” to factory defaults. Issuing the freset command with
the “target” field set to standard, resets the userdata NVM as well as OEMV parameters as indicated
in the OEMV Family Firmware Reference Manual.
The DL-V3 factory default command list is on Page 96.
If you issue the FRESET command without any parameters, it is the same as issuing a FRESET
STANDARD command.
Table 24: FRESET Target
Fiel
d
Field
Type
ASCII
Value
Binar
y
Value
Description
Binary
Forma
t
Binar
y
Bytes
Binar
y
Offset
1FRESET
header
- - This field contains the command name
or the message header depending on
whether the command is abbreviated
ASCII, ASCII or binary, respectively.
-H0
2 target See Table 24 Data to be reset by the receiver Enum 4 H
Binary ASCII Description
0 STANDARD Resets commands, ephemeris, and almanac (default). Also resets all L-
band related data except for subscription information.
1 COMMAND Resets the stored commands (saved configuration)
2 GPSALMANAC Resets the stored GPS almanac
3 GPSEPHEM Resets the stored GPS ephemeris
4 GLOEPHEM Resets the stored GLONASS ephemeris
5 MODEL Resets the currently selected model
10 USERDATA Reset DL-V3-only commands
11 CLKCALIBRATION Resets the parameters entered using the CLOCKCALIBRATE command
20 SBASALMANAC Resets the stored SBAS almanac
21 LAST_POSITION Resets the position using the last stored position
31 GLOALMANAC Resets the stored GLONASS almanac