Filter
Top Products
DL-V3 User Manual Rev 3 25
Chapter 2 Installation and Setup
This chapter contains instructions and tips to set up your DL-V3 to create a GNSS receiver system.
2.1 Additional Equipment Required
In order for the receiver to perform optimally, the following additional equipment is required:
• A NovAtel GNSS antenna (user-supplied, NovAtel recommended)
• A quality coaxial cable, and interconnect adapter cable as necessary (user-supplied)
• A PC/laptop (user-supplied)
• A means of communicating between the DL-V3 and PC/laptop
• Serial null-modem cable (included with the receiver, NovAtel part number
01017658), see Figure 8, DB-9 Setup on Page 28
• USB cable (user-supplied), see Figure 9, USB Setup on Page 28
• Ethernet crossover cable (user-supplied), see Figure 11, Ethernet Setup on Page 29
• Bluetooth link (user-supplied), see Figure 10, Bluetooth Setup on Page 29
Use a serial COM or USB connection to communicate with the receiver
first. This will give you the ability to configure the PC/laptop and DL-V3
before Ethernet or Bluetooth use.
• A power supply (user-supplied)
• A power cable (included with the receiver)
CAUTION: When the DL-V3 is installed in a permanent location, such as in a building, it
should be protected by a lightning protection device according to local building
codes. See also Warranty on Page 15.
2.1.1 DL-V3 Setup
Complete the steps below to connect and power your DL-V3. See also Figures 8 to 11 starting on
Page 28.
1. Mount a GNSS antenna on a secure, stable structure with an unobstructed view of the sky from
horizon to horizon, see Section 2.1.7, Mounting the GNSS Antenna on Page 32.
2. Ensure a CF card is in the slot behind the door on the front face of the DL-V3. Open, or secure,
the door by turning the latch. See also Section 2.2.6, DL-V3 Removable Compact Flash Memory
Card starting on Page 39.
Once the CF card is installed, ensure that it is properly formatted, see
Page 39.