Filter
Top Products
DL-V3 User Manual Rev 3 127
B.29 METHUMID Specify Air Humidity
The methumid command allows you to specify air humidity. Humidity specified with the methumid
command does not affect receiver operation. Rather, it allows you to create a record of atmospheric
conditions for post-processing purposes.
The methumid set command specifies air humidity at humid. This command only stores the humidity
value in volatile memory, and does not automatically generate a record. The humidity value can then
be displayed/recorded by requesting the met log.
The methumid clear and the methumid default commands clear the humidity setting.
Syntax
methumid set [humid]
methumid default|clear
Message ID = 163
Table 49: METHUMID Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1 Header - - - 0
2 Parameter Update, see
Table 34 on Page 107
- 4 Enum none H
3 Humidity 0 4 Float percent H+4
Parameter Power-On Freset Stored in NVM
methumid clear clear NO