Filter
Top Products
138 DL-V3 User Manual Rev 3
B.38 SITEUPDATENAME Set Occupied Site Name
The siteupdatename command allows you to configure the site name information (SiteName field in
the sitedef log) once the site has been occupied (by issuing a site enter command).
The siteupdatename set command sets the site name for an occupied site to sitename.
The siteupdatename default command sets the name to “SITE”.
The siteupdatename clear command has no effect.
Syntax
siteupdatename set sitename
siteupdatename default|clear
Message ID = 170
Table 59: SITEUPDATENAME Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1 Header - - - 0
2 Parameter Update, see
Table 34 on Page 107
- 4 Enum none H
3 Site name - 32 Char[] none H+4
4 Reserved for future use NUL 12 Char[] none H+36
Parameter Power-On Freset Stored in NVM
Site Name clear clear NO