Filter
Top Products
DL-V3 User Manual Rev 3 99
B.13 GROUPANTTYPE Edit Group Antenna Type
The groupanttype command allows you to edit the antenna type definition for the group.
The groupanttype set command sets the antenna type for the group named groupname to anttype.
The groupanttype clear and the groupanttype default commands remove the antenna type setting from
the group named groupname.
Syntax
groupanttype set groupname [anttype]
groupanttype default|clear groupname
B.13.1 Groupuse Translation
groupuse start
• The antenna type is reflected in the groupdef log.
If an automatic site is being generated (see groupmode on Page 113), the group antenna type is used in
site configuration.
groupuse stop
N/A
Message ID = 65
Table 29: GROUPANTTYPE Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1Header - - - 0
2 Parameter Update, see Table 34
on Page 107
- 4 Enum none H
3 Group name - 12 Char[] none H+4
4 Antenna type, see Table 29 NUL 16 Char[] none H+16
Parameter Power-On Freset Stored in NVM
anttype no change NUL YES