Filter
Top Products
108 DL-V3 User Manual Rev 3
B.18 GROUPFIXPOS Configure Group to Fix Receiver Position
The groupfixpos command allows you to configure the group to fix the receiver position when the
group is executed. groupfixpos and groupposave configurations are mutually exclusive, and the last
setting to be entered takes effect.
groupfixpos set configures the group to fix the position to lat long height. groupfixpos clear clears the
group position-fix configuration. groupfixpos default clears the group position-fix configuration.
Syntax
groupfixpos set groupname [lat [long [height]]]
groupfixpos default|clear groupname
B.18.1 Groupuse Translation
groupuse start
If position fixing is configured in the group, the fix position command is executed with the supplied
parameters.
groupuse stop
If position fixing is configured in the group, issues a fix none command.
Message ID = 58
Table 36: GROUPFIXPOS Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1 Header - - - 0
2 Parameter Update, see Table 34
on Page 107
- 4 Enum none H
3 Group name - 12 Char[] none H+4
4 Latitude 0 8 Double degrees H+16
5 Longitude 0 8 Double degrees H+24
6 Height 0 8 Double metres H+32
7
Reserved for future use
-1 4 Int none H+40
8 -1 4 Int none H+44
Parameter Power-On Freset Stored in NVM
Fixed Position Configuration no change CLEAR YES