Filter
Top Products
48 DL-V3 User Manual Rev 3
Chapter 3 Operation
Figure 17: Basic Differential Setup
Reference Description
1 A DL-V3 receiver for the rover station
2 NovAtel GNSS antenna
3 User-supplied data storage device to COM1
4 User-supplied power supply
5 User-supplied radio device to COM2
6 A DL-V3 receiver for the base station
7 User-supplied PC/laptop, for setting up and monitoring, to COM1
See also Appendix D, Ethernet Configuration starting on Page 178 for Ethernet and
Appendix E, Bluetooth Configuration starting on Page 195 for Bluetooth configuration
options.
System biases can introduce errors, as described in the Modes of Operation chapter in the OEMV
Family Installation and Operation User Manual. In most cases you need to provide a data link
between the base station and rover station (two NovAtel receivers) in order to receive corrections.
SBAS and L-band corrections can be accomplished with one receiver and are exceptions to the base/
rover concept. Generally a link capable of data throughput at a rate of 9600 bits per second, and less
than 4.0 s latency, is recommended.
Once your base and rover are set up, you can configure them as shown in the configuration examples
that follow in Sections 3.3.1 - 3.3.2 starting on Page 50.
4
1
12V
2
4
Base
Rover
5
3