Filter
Top Products
DL-V3 User Manual Rev 3 119
The groupuse stop command interprets the group configuration as follows:
• The groupuse destination list is assembled, representing all destinations to be used
by the group.
• For each destination in the groupuse destination list, an unlogall command is
issued (for the particular virtual channel).
• If the groupuse destination list contains any FILE_n destinations, and a site has
been defined, a site leave command is issued.
• For each FILE_n destination in the groupuse destination list, a logfile command is
issued, terminating the associated destination with the logfile.
• groupposfix or groupposave configuration is executed.
1. An OK response to the groupuse command does not guarantee that all steps in the groupuse
sequence have completed successfully.
2. A response to the groupuse command does not guarantee that the sequence has completed
execution. If it is important to guarantee that a subsequent command is executed after the
entire groupuse sequence has been completed, the “Groupuse execution in progress” bit in
the Auxiliary 2 status word in the rxstatus log, see Page 172, should be used.
Syntax
groupuse start|stop groupname [dst] [filename]
Message ID = 149
Table 45: Group Action
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1 Header - - - 0
2 Group Action, see Table 45 on
Page 119
- 4 Enum none H
3 Group name - 12 Char[] none H+4
4 Serial Port Identifier, see
Appendix C, Logs, Table 67 on
Page 150
THISPORT 4 Enum none H+16
5 Filename NUL 12 Char[] none H+20
Binary Value ASCII Value Description
0 START Start the specified group
1 STOP Stop the specified group