Filter
Top Products
140 DL-V3 User Manual Rev 3
B.40 SITEUPDATEANTTYPE Set Occupied Site Antenna
The siteupdateanttype command allows you to configure the site antenna type information (AntType
field in the sitedef log) once the site has been occupied (by issuing a site enter command).
The siteupdateanttype set command sets the site antenna type for an occupied site to anttype.
The siteupdateanttype default and the siteupdateanttype clear commands clear the site antenna type
for an occupied site.
The siteupdateanttype clear command clears the site antenna type for an occupied site.
Syntax
siteupdateanttype set [anttype]
siteupdateanttype default|clear
Message ID = 168
Table 61: SITEUPDATEANTTYPE Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1 Header - - - 0
2 Parameter Update, see Table 34 on
Page 107
- 4 Enum none H
3 Antenna type NUL 16 Char[] none H+4
4 Reserved for future use NUL 12 Char[] none H+20
Parameter Power-On Freset Stored in NVM
AntType clear clear NO