Filter
Top Products
DL-V3 User Manual Rev 3 139
B.39 SITEUPDATEANTHEIGHT Set Occupied Site Height
The siteupdateantheight command allows you to configure the site antenna height information
(AntHeight field in the sitedef log) once the site has been occupied (by issuing a site enter
command).
The siteupdateantheight set command sets the site antenna height for an occupied site to antheight.
The siteupdateantheight default and the siteupdateantheight clear commands clear the site antenna
height for an occupied site.
Syntax
siteupdateantheight set [antheight]
siteupdateantheight default|clear
Message ID = 167
Table 60: SITEUPDATEANTHEIGHT Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1Header - - -0
2 Parameter Update, see
Table 34 on Page 107
- 4 Enum none H
3 Antenna height 0 4 Float none H+4
4 Reserved for future use NUL 12 Char[] none H+8
Parameter Power-On Freset Stored in NVM
AntHeight clear clear NO