Filter
Top Products
DL-V3 User Manual Rev 3 115
B.23 GROUPSATLIMIT Limit Number of Satellites for Group
The groupsatlimit command allows you to limit the number of satellites used for the group. The
groupsatlimit set command sets satlimit for the group named groupname to satlimit. The groupsatlimit
clear command removes the satlimit setting from the group named groupname. The groupsatlimit
default command sets the satlimit for the group to 0.
Syntax
groupsatlimit set groupname [satlimit]
groupsatlimit default|clear groupname
B.23.1 Groupuse Translation
groupuse start
If set, the satlimit command, see Page 133, is issued for each virtual channel associated with a logfile
by this groupuse start command.
groupuse stop
N/A
Message ID = 62
Table 42: GROUPSATLIMIT Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1 Header - - - 0
2 Parameter Update, see
Table 34 on Page 107
- 4 Enum none H
3 Group name - 12 Char[] none H+4
4 Satellite limit 0 4 Int none H+16
Parameter Power-On Freset Stored in NVM
Satellite Limit no change 0 YES