Filter
Top Products
DL-V3 User Manual Rev 3 109
B.19 GROUPINTERFACEMODE Edit Group Interface Mode
The groupinterfacemode command allows you to edit the interface mode configuration for the group.
The group can be configured to issue the interfacemode command to COM1, COM2 and/or AUX.
The groupinterfacemode set command sets the interface mode configuration for the group named
groupname and port to the specified parameters (refer to the interfacemode command in the OEMV
Family Firmware Reference Manual, for further details on rx_type, tx_type and responses). Port can
be COM1, COM2 our AUX.
The groupinterfacemode clear and the groupinterfacemode default commands remove (disable) the
interface mode configuration for all ports from the group named groupname.
Syntax
groupinterfacemode set
groupname [port] [rx_type [tx_type]]
[responses]
groupinterfacemode default|clear groupname
B.19.1 Groupuse Translation
groupuse start
If set for the particular port, the interfacemode command is issued for the port.
groupuse stop
N/A
Message ID = 318
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1Header - - - 0
2 Parameter Update, see Table 34 on
Page 107
- 4 Enum none H
3 Group name - 12 Char[] none H+4
4 Serial Port Identifier, see Appendix
C, Logs, Table 67 on Page 150
NO_PORT 4 Enum none H+16
5 rx_type – Serial Port Interface
Mode, see Table 70 on Page 151
NOVATEL 4 Enum none H+20
6 tx_type – Serial Port Interface Mode,
see Table 70 on Page 151
NOVATEL 4 Enum none H+24
7 Responses
0 = Off
1 = On
ON 4 Enum none H+28