Filter
Top Products
DL-V3 User Manual Rev 3 185
9. Click OK when you are returned to the Local Area Connection Properties dialog.
10. Click Close to complete the network configuration.
11. Restart the laptop for the settings to take effect.
D.2.3.1 Network Settings Configuration
Use a web browser to connect the PC/laptop, via the Ethernet cross-over cable, to the Ethernet port on
the DL-V3.
Type http://192.168.1.223 in the Address field of the web browser. The authentication dialog prompts
you for the username and password. Use admin as the username and PASS as the password. The
Lantronix Ethernet device page opens where the Ethernet settings can be changed manually.
Use the appcontrol option 12 9 command in CDU to reset the Ethernet settings back to their defaults.
The Ethernet device is now ready to communicate with the DL-V3. In order for a client to
communicate with the Ethernet device using existing communications tools such as HyperTerminal,
the Ethernet device’s IP address must be mapped to a virtual serial port within the Lantronix Port
Redirector utility. Section D.2.4, Lantronix Port Redirector Software, starting below, describes the
configuration process.
D.2.4 Lantronix Port Redirector Software
Run the Lantronix COM Port Redirector (CPR) Manager software from the Start | All Programs |
Lantronix menu.
The main CPR Manager screen appears, see Figure 40 on Page 186. Select the General Tests tab.