Filter
Top Products
194 DL-V3 User Manual Rev 3
18. Choose 115200 in the Bits per second: field.
19. Click OK.
20. Switch the null-modem cable connection on the DL-V3 from the COM2 port to the COM1 port.
21. Re-connect HyperTerminal and type the following commands to COM1:
• exit
Type YES when asked to reboot or reload the system. For example, after you see:
reload\r
• yes
22. Switch the null-modem cable connection on the DL-V3 from the COM1 port to the COM2 port
23. Type RESET on COM2, or push and hold the power button on the DL-V3 and wait for the LEDs
to indicate that the unit is powering off before releasing the power button, or physically remove
power from the DL-V3. This step restores COM1 and COM3 by resetting the unit.
This concludes the Ethernet configuration via Serial Command Mode. Next, see the Lantronix Port
Redirector Software section starting on Page 185 to configure Lantronix Port-Redirector software to
configure a Lantronix virtual serial port in Windows XP.
115200