Filter
Top Products
DL-V3 User Manual Rev 3 97
B.11 GROUPANTHEIGHT Edit Group Antenna Height
The groupantheight command allows you to edit the antenna height definition for the group.
The groupantheight set command sets the antenna height for the group named groupname to
antheight.
The groupantheight clear command removes the antenna height setting from the group named
groupname.
The groupantheight default command sets the antenna height for the group to 0.
Syntax
groupantheight set groupname [antheight]
groupantheight default|clear groupname
B.11.1 Groupuse Translation
groupuse start
The antenna height setting is reflected in the groupdef log.
If an automatic site is being generated (see groupmode), the group antenna height is used in site
configuration.
groupuse stop
Not Applicable (N/A)
Message ID = 66
Table 27: GROUPANTHEIGHT Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1 Header - - - 0
2
Parameter Update, see Table 34
on Page 107
- 4 Enum none H
3 Group name - 12 Char[] none H+4
4 Antenna height, see Table 27 0 4 Float none H+16
Parameter Power-On Freset Stored in NVM
antheight no change 0 YES