Filter
Top Products
DL-V3 User Manual Rev 3 141
B.41 SITEUPDATEATTRIBUTE Set Occupied Site Attributes
The siteupdateattribute command allows you to configure the site attribute information (Attrib field in
the sitedef log) once the site has been occupied (by issuing a site enter command).
The siteupdateattribute set command sets the site attribute for an occupied site to attrib.
The siteupdateattribute default and the siteupdateattribute clear commands clear the site attribute for
an occupied site.
Syntax
siteupdateattribute set [attrib]
siteupdateattribute default|clear
Message ID = 169
Table 62: SITEUPDATEATTRIBUTE Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1 Header - - - 0
2 Parameter Update, see
Table 34 on Page 107
- 4 Enum none H
3 Attribute 0 4 Int none H+4
4 Reserved for future use NUL 12 Char[] none H+8
Parameter Power-On Freset Stored in NVM
Attribute
clear
clear NO