Filter
Top Products
DL-V3 User Manual Rev 3 151
Table 70: Serial Port Interface Modes
Binary Value ASCII Mode Name Description
0 NONE The port accepts/generates nothing
1 NOVATEL The port accepts/generates NovAtel commands and logs
2 RTCM The port accepts/generates RTCM corrections
3 RTCA The port accepts/generates RTCA corrections
4 CMR The port accepts/generates CMR corrections
5
Reserved
6
7
8 RTCMNOCR
RTCM with no CR/LF appended
a
9 CDGPS
The port accepts GPS*C data
b
10 TCOM1 INTERFACEMODE tunnel modes. To configure a full duplex
tunnel, configure the baud rate on each port. Once a tunnel is
established, the baud rate does not change. Special characters,
such as a BREAK condition, do not route across the tunnel
transparently and the serial port is altered. Refer to the COM
command in the OEMV Family Firmware Reference Manual.
Only serial ports may be in a tunnel configuration:
COM1, COM2, COM3 or AUX may be used.
For example, configure a tunnel at 115200 bps between COM1
and COM3:
COM AUX 115200
COM COM1 115200
INTERFACEMODE COM3 TCOM1 NONE OFF
INTERFACEMODE COM1 TCOM3 NONE OFF
The tunnel is fully configured to receive/transmit at a baud rate
of 115200 bps.
11 TCOM2
12 TCOM3
13
TAUX
c
14 RTCMV3 The port accepts/generates RTCM Version 3.0 corrections
15 NOVATELBINARY The port only accepts/generates binary messages. If an ASCII
command is entered when the mode is set to binary only, the
command is ignored. Only properly formatted binary messages
are responded to and the response is a binary message.
Continued on Page 152