Filter
Top Products
DL-V3 User Manual Rev 3 113
B.21 GROUPMODE Configure Group Survey Type
The groupmode command configures the survey type for a survey carried out with the group.
The groupmode set kinematic|static command sets the survey type for the group named groupname to
the specified mode. The groupmode clear command sets the survey type for the group to static. The
groupmode default command sets the survey type for the group to static.
Syntax
groupmode set groupname [kinematic|static]
groupmode default|clear groupname
B.21.1 Groupuse Translation
groupuse start
If the groupmode is set to static, a site add command is executed, and the site is configured with
parameters defined by groupantheight, groupsitenumber, groupsitename, and groupanttype
commands.
groupuse stop
N/A
Message ID = 57
Table 39: Group Mode
Table 40: GROUPMODE Default Configuration
Field Data
Value Used if
Not Specified
Bytes Format Units Offset
1 Header - - - 0
2 Parameter Update, see Table 34 on
Page 107
- 4 Enum none H
3 Group name - 12 Char[] none H+4
4 Group Mode, see Table 39 STATIC 4 Enum none H+16
Binary Value ASCII Value Description
0 STATIC Set group mode to static
1 KINEMATIC Set group mode to kinematic
Parameter Power-On Freset Stored in NVM
Group Mode no change KINEMATIC YES