Filter
Top Products
13 - 5
13. COMMUNICATION FUNCTIONS
13.2.2 Parameter setting
When the RS-422/RS-232C communication function is used to operate the servo, set the communication
specifications of the servo amplifier in the corresponding parameters.
After setting the values of these parameters, they are made valid by switching power off once, then on
again.
(1) Serial communication baudrate
Choose the communication speed. Match this value to the communication speed of the sending end
(master station).
Communication baudrate selection
0: 9600[bps]
1: 19200[bps]
2: 38400[bps]
3: 57600[bps]
IFU parameter No. 0
(2) Serial communication selection
Select the RS-422 or RS-232C communication standard. RS-422 and RS-232C cannot be used together.
Serial communication standard selection
0: RS-232C used
1: RS-422 used
IFU parameter No. 0
(3) Serial communication response delay time
Set the time from when the servo amplifier (slave station) receives communication data to when it
sends back data. Set "0" to send back data in less than 800
s or "1" to send back data in 800 s or more.
Serial communication response delay time selection
0: Invalid
1: Valid, reply sent in 800 s or more
IFU parameter No. 0
(4) Station number setting
In IFU parameter No. 10 to 18, set the station numbers of the units connected to the slots. Do not use
the station numbers used by the other units.
IFU parameter No. Slot Whose Station Number Is Set Default Station Number Usable Station Numbers
10 Interface unit slot 0
11 Slot 1 1
12 Slot 2 2
13 Slot 3 3
14 Slot 4 4
15 Slot 5 5
16 Slot 6 6
17 Slot 7 7
18 Slot 8 8
0 to 31