Filter
Top Products
4 - 9
4. OPERATION AND DISPLAY
4.2.5 Interface unit parameter mode
The parameters whose abbreviations are marked* are made valid by changing the setting and then
switching power off once and switching it on again. Refer to Section 5.2.2.
The following example shows the operation procedure performed after power-on to change the
regenerative brake resistor (IFU parameter No. 1) to 0005 (MR-RB15).
Using the "MODE" button, show the basic parameter screen.
UP DOWN
The parameter number is displayed.
Press or button to change the number.
Press SET twice.
The set value of the specified parameter number flickers.
Press UP fifth.
During flickering, the set value can be changed.
Use or button .
Press SET to enter.
( 5: regenerative brake option MR-RB14)
UP DOWN
Pressing the "MODE" button during a parameter setting display or setting change display cancels the
processing and returns to a parameter number display.
To shift to the next parameter, press the "UP" or "DOWN" button.