Filter
Top Products
5 - 1
5. PARAMETERS
5. PARAMETERS
CAUTION
When using the MR-J3- T servo amplifier with the MR-J3-D01 extension I/O unit,
always refer to the parameters indicated in this chapter. Some parameters have
different functions when they are used with the MR-J3-
T servo amplifier alone.
Never adjust or change the parameter values extremely as it will make operation
instable.
POINT
For any parameter whose symbol is preceded by *, set the parameter value
and switch power off once, then switch it on again to make that parameter
setting valid.
In this servo amplifier, the parameters are classified into the following groups on a function basis.
Parameter group Main description
Basic setting parameters
(No. PA
)
Make basic setting with these parameters. Generally, the operation is possible only with these
parameter settings.
Gain/filter parameters
(No. PB
)
Use these parameters when making gain adjustment manually.
Extension setting parameters
(No. PC
)
These parameters are inherent to the MR-J3-
T servo amplifier.
I/O setting parameters
(No. PD
)
Use these parameters when changing the I/O devices of the servo amplifier.
Option unit parameters
(No. Po
)
These parameters are for MR-J3-D01 extension I/O unit.
Mainly setting the basic setting parameters (No. PA ) allows the setting of the basic parameters at the
time of introduction.