Filter
Top Products
14 - 36
14. COMMUNICATION FUNCTION
(4) Single-step feed
Set necessary items to the point table before starting the single-step feed.
Send the command, data No. and data as indicated below to execute single-step feed.
Command : [9 ][2]
Data No. : [0][0]
Data : 00020807
(ST1 is ON)
Operation start
Command : [8 ][B]
Data No. : [0][0]
Data : 0000
(Single-step feed cancel)
End
(Note)
Power on the servo amplifier.
Command : [9 ][2]
Data No. : [0][0]
Data : 00020801
(ST1 is ON)
Operation start
(Note)
When LSP/LSN was turned OFF by external
input signal or automatically turned ON
Command : [9 ][2]
Data No. : [0][0]
Data : 00020001
(SON, MD0 turned ON)
Make input device valid Make input device valid
When LSP/LSN was turned OFF by
external input signal
Turn ON Servo-on (SON) to make
the servo amplifier ready.
Start.
Cancel the single-step feed.
Command : [9 ][2]
Data No. : [0][0]
Data : 00020007
(SON, LSP, LSN, MD0
turned ON)
Command : [8 ][B]
Data No. : [0][0]
Data : 0005 (Single-step feed)
Comma nd : [9][2]
Data No. : [0][1]
Data : Write the point table No. in
hexadecimal.
Point table No. setting
Start
Select the single-step feed in the
test operation mode.
Set the point table No.
Shift to the usually operation mode.