Filter
Top Products
14 - 47
14. COMMUNICATION FUNCTION
(f) Auxiliary function
Write the auxiliary function of the point table.
Transmit command [C][B], any of data No. [0][1] to [F][F] corresponding to the point table to be written
to, and the data. Refer to section 14.4.2.
Command Data No. Data
[C][B] [0][1] to [F][F] See below.
0
Hexadecimal data
Write mode
0: EEP-ROM, RAM write
1: RAM write
When the auxiliary function constant is changed frequently through communication,
set "1" to the write mode to change only the RAM data in the servo amplifier.
When changing data frequently (once or more within one hour),
do not write it to the EEP-ROM.
(g) M code
Write the M code of the point table.
Transmit command [C][B], any of data No. [0][1] to [F][F] corresponding to the point table to be written
to, and the data. Refer to section 14.4.2.
Command Data No. Data
[C][B] [0][1] to [F][F] See below.
0
Hexadecimal data
Write mode
0: EEP-ROM, RAM write
1: RAM write
When the M code constant is changed frequently through communication,
set "1" to the write mode to change only the RAM data in the servo amplifier.
When changing data frequently (once or more within one hour),
do not write it to the EEP-ROM.