Filter
Top Products
14 - 44
14. COMMUNICATION FUNCTION
(g) M code
Read the M code of the point table.
1) Transmission
Transmit command [4][5] and any of data No. [0][1] to [F][F] corresponding to the point table to be
read. Refer to section 14.4.1.
2) Reply
The slave station sends back the M code of the requested point table.
0
Hexadecimal data
Display type
0: Used unchanged in hexadecimal
1: Conversion into decimal required
M code write type
0: Valid after write
1: Valid when power is switched on again after write
00