Filter
Top Products
8 - 20
8. PARAMETER UNIT (MR-PRU03)
(2) Messages
Message Description
Valid parameters were written when power is off.
The MR-PRU03 parameter unit was used to set a station number and perform transition during the test
operation mode.
Operation mode is the test operation mode.
The test mode was changed due to external factor.
Reading settings specified for the parameter write disable (parameter No.PA19) was attempted.
In the test operation, the "ESC" key was pressed while the "Fn" key was held down to switch the screen to the
MR-PRU03 parameter unit setting screen.
The ready cannot be turned ON due to alarm, etc.
Operation mode can be switched to the test operation mode at servo-on.
Station number change was attempted in the test operation mode.
Point table No. change was attempted in the single-step feed operation.