63230-300-212 Chapter 6—Alarms
April 2001 Alarm Conditions and Alarm Numbers
93
© 2001 Schneider Electric All Rights Reserved
This section lists the circuit monitor’s predefined alarm conditions. For each
alarm condition, the following information is provided.
• Alarm No.—a position number indicating where an alarm falls in the list.
• Alarm Description—a brief description of the alarm condition
• Abbreviated Display Name—an abbreviated name that describes the
alarm condition, but is limited to 15 characters that fit in the window of the
circuit monitor’sdisplay.
• Test Register—the register number that contains the value (where
applicable) that is used as the basis for a comparison to alarm pickup and
dropout settings.
• Units—the unit that applies to the pickup and dropout settings.
• Scale Group—the scale group that applies to the test register’s metering
value (A–F). For a description of scale groups, see “Scale Factors” on
page 91.
• Alarm Type—a reference to a definition that provides details on the
operation and configuration of the alarm. For a description of alarm types,
refer to Table 6–4 on page 96.
Table 6–3 on page 94 lists the preconfigured alarms by alarm number.
ALARM CONDITIONS AND
ALARM NUMBERS