Filter
Top Products
63230-300-212 Chapter 7—Logging
April 2001 Chapter Contents
99
© 2001 Schneider Electric All Rights Reserved
This chapter briefly describes the following logs of the circuit monitor:
• Alarm log
• User-defined data logs
• Min/Max log and Interval Min/Max/Average log
• Maintenance log
Logs are files stored in the nonvolatile memory of circuit monitor and are
referred to as “onboard logs.” Use
SMS to set up and view all the logs. See
the
SMS online help for information about working with the circuit monitor’s
onboard logs. Waveform captures and the 100-ms rms event recording are
not logs, but the information is also saved in the circuit monitor’s memory.
See “Memory Allocation” on page 104 for information about shared memory
in the circuit monitor. For information about default circuit monitor settings,
see “Factory Defaults” on page 11 of the installation manual.
CHAPTERCONTENTS ......................................99
ALARMLOG ..............................................100
AlarmLogStorage......................................100
DATALOGS ..............................................100
Alarm-DrivenDataLogEntries ............................101
OrganizingDataLogFiles ................................101
DataLogStorage.......................................101
MIN/MAXLOGS ...........................................102
Min/MaxLog ..........................................102
IntervalMin/Max/AverageLog .............................102
IntervalMin/Max/AverageLogStorage ..................103
MAINTENANCELOG .......................................103
MEMORYALLOCATION ....................................104
CHAPTER 7—LOGGING
CHAPTER CONTENTS