Filter
Top Products
Chapter 9—Disturbance Monitoring 63230-300-212
Using the Circuit Monitor with SMS to Perform Disturbance Monitoring April 2001
© 2001 Schneider Electric All Rights Reserved
118
This section gives you an overview of the steps to set up the circuit monitor
for disturbance monitoring. For detailed instructions, see the
SMS online
help. In
SMS under Setup > Devices Routing, the Device Setup dialog box
contains the tabs for setting up disturbance monitoring. After you have
performed basic set up of the circuit monitor, perform three setup steps:
1. Define the storage space for the alarm log, waveform capture, and any
forced data logs using the Onboard Files tab in
SMS. This sets up the
amount of circuit monitor memory that the logs and waveform capture
will use.
Figure 9–3: Onboard Files tab
2. Associate an alarm with data logs and waveform/event captures using the
Onboard Alarms/Events tab.
Figure 9–4: Onboard Alarms/Events tab
3. In addition, you can set up a relay to operate upon an event using the
I/O tab in
SMS.
NOTE: For the I/O Extender, you must define the relay from the display
before
SMS
can recognize it. See “Setting Up I/Os” on page 23 of this
bulletin for instructions.
USING THE CIRCUIT MONITOR WITH
SMS TO PERFORM DISTURBANCE
MONITORING
Select a
data log
Define the size of
the waveform or
event capture
Select how
the log will
save data
Define the alarm
Enable the alarm
Select data logs
and/or waveform
captures be
associated with the
alarm